- What is the difference between gain master volume?
- What is the difference between gain and volume on an amplifier?
- How loud is a 100 watt amp?
- Are tube amps really better?
- Do attenuators affect tone?
- What does Master Volume on AMP do?
- Is Master Volume an attenuator?
- Do tube amps sound better loud?
- Why does my tube amp sound bad?
- Do attenuators degrade sound quality?
- How loud can a 50 watt amp get?
- What is the difference between volume and master volume on a guitar amp?
What is the difference between gain master volume?
Your gain setting determines how hard you’re driving the preamp section of your amp.
Setting the gain control sets the level of distortion in your tone, regardless of how loud the final volume is set.
Master volume is an entirely separate entity that lives in the second stage of your amp, the power amp section..
What is the difference between gain and volume on an amplifier?
Volume is how loud the OUTPUT of the channel or amp is. It controls loudness, not tone. Gain is how loud the INPUT of the channel or amp is. It controls tone, not loudness.
How loud is a 100 watt amp?
The same thing holds true at higher wattages—a 100W amp is not going to sound twice as loud as a 50W amp; assuming identical speakers, it will only be 3 dB louder, which is noticeable, but definitely not a doubling of perceived loudness.
Are tube amps really better?
Tube amplifiers sound better because of the euphonic distortions they add to the music, as well as plenty of other reasons I’ll cover below. … The ways that tubes distort when pushed to the edge are much more musical than the artificial sounds that come from transistor amplifiers when overdriven.
Do attenuators affect tone?
Yep, attenuators do affect the tone. While I don’t have an attenuator, I have played amps that have had built-in attenuators. If you didn’t adjust the controls after engaging the attenuators, the amps (even the overpriced THD Univalve) sounded muddy.
What does Master Volume on AMP do?
This refers to a feature sound on many modern tube amplifiers (and some solid-state and modeled amps, as well). Essentially, it allows guitarists to turn the volume control up to overdrive the preamps, producing a sweet compressed sustain, but without the high output normally required on stage.
Is Master Volume an attenuator?
One common misconception is that a master volume control will achieve the same effect as an attenuator. However, because a master volume knob is still a part of the amplifier’s preamp section, it has an entirely different effect on the circuit — and therefore, the overall tone. … WILL AN ATTENUATOR CHANGE MY TONE?
Do tube amps sound better loud?
tube amps sound great at bedroom volumes…they sound better at louder volumes.
Why does my tube amp sound bad?
Most guitar amps have a gain or drive knob or pre-gain and post-gain knobs. When these knobs are adjusted in the right way, it brings distortion into your tone. … You should hear your tone start to distort. Keep adjusting the gain and volume knobs until you get the right amount of distortion at the volume level you want.
Do attenuators degrade sound quality?
Attenuators can reduce the input impedance of the amp and that could affect sound quality. However, a signal that is too loud could also have been overloading the input to the amp and that might have thickened the sound up a bit…
How loud can a 50 watt amp get?
A 50-watt amp is only 3 db (decibels, the unit volume is measured by) quieter than a 100-watt amp. Going further, a 30-watt amp is only 5 db quieter. And, somewhat astoundingly, a little 10-watt amp is actually half as loud (or -10 db) as the 100-watt amp!
What is the difference between volume and master volume on a guitar amp?
the first volume controls the amount of signal going through the preamp section. the second volume (master volume) controls the amount of signal going through the power amp section.