Quick Answer: Does Touching The Battery Cables Together To Reset Computer?

Can you touch battery terminals together?

Touching both the positive and negative will discharge what ever remaining power is in the ECU.

Even after your battery is removed, touching the 2 terminals together (with out even having any source of power) you will even create a small spark, draining what’s left..

What happens if you disconnect the positive terminal first?

If you begin to remove the positive side before the negative and your wrench would make contact with any part of the vehicle, then you could cause a short in the system. This could in turn blow fuses and relays or even damage some of the sensitive electronics on your 2016 Chevrolet Tahoe.

Do I hook up the negative or positive first?

When disconnecting the cables from the old battery, disconnect the negative first, then the positive. Connect the new battery in the reverse order, positive then negative.” When you are replacing your car battery, It isn’t always easy to remember the order in which to disconnect and reconnect the terminals.

What happens if you don’t disconnect the negative battery cable?

Never disconnect a battery cable when the engine is running. If the tool touches the battery positive terminal and a chassis ground simultaneously, as long as the negative battery cable is not connected, no damage will occur.

Do you put red or black on first?

In order to allow for a jump start to work properly, one must ensure that the correct terminals are being connected. The red cable will always represent the side that should be attached to the positive terminal, and the black should be attached to the negative terminal.

Does disconnecting the battery reset the ECU?

Will disconnecting battery reset ECU? Can a ECU be reset? Yes, all ECU (Engine Control units) can be reset and be should reset once per manufacturer’s guideline for a smooth relearn process or upon installing a replacement unit.

How long do I need to disconnect battery to reset computer?

How to Disconnect a Car Battery to Reset the ComputerClean any corrosion off of the battery and terminals with a can of spray-on battery cleaner. … Hold the positive and negative cable ends together so they’re touching each other but not the battery.Wait five minutes for the diagnostic information to be erased.

How do you reset your car’s computer?

How to Reset a Car ComputerOpen up the hood.Remove the positive terminal cable from the battery using your pliers or wrench.Go to your fuse box in your car, and look at the diagram. … Keep the car disconnected like this for two to three minutes to clear the computer’s memory.Insert the fuse back in to the box.

Which battery terminal do I connect first?

Connect the positive end first. Attach the red/positive (+) cable to the red/positive (+) battery post and tighten with a wrench. Do the same on the black/negative (-) side. Ensure that the connections on both ends are secure by trying to move the battery around.